Request for

Contact us at or 9819133129 to enquire about wholesale rates.

Read more
Power over Ethernet HAT for Raspberry Pi 3B+ and 802.3af PoE network

Power over Ethernet HAT for Raspberry Pi 3B+ and 802.3af PoE network - Waveshare

Manufacturer: Waveshare
Part No: 15322
Availability: In Stock

Ask a question about this product

I wish to not have this question published

Power over Ethernet HAT for Raspberry Pi 3 Model B+, 802.3af power-sourcing equipment required

Key Features

➤ 802.3af PoE
➤ Fully isolated switched-mode power supply
➤ 37–57V DC, Class 2 device
➤ 5V/2.5A DC output
➤ 25mm x 25mm brushless fan for processor cooling
➤ Fan control

How to:

Hardware Required

➤ Raspberry Pi PoE HAT
➤ A Raspberry Pi 3 Model B+
➤ An Ethernet cable
➤ Power-sourcing equipment for a 802.3af Power over Ethernet network

Connecting your PoE HAT to the Raspberry Pi

➤ Before installing the PoE HAT, you must attach the supplied spacers in the four corners of the board
➤ Then connect the Raspberry Pi PoE HAT to the two 0.1” headers (40 + 4) that are fitted on the Raspberry Pi
➤ Once the PoE HAT board is connected, you can power the Raspberry Pi through its RJ45 network connector

➤ The fan will turn on and off automatically depending on the temperature of the main processor on the Raspberry Pi.

Disconnecting your PoE HAT

➤ Pull evenly so that it detaches from all the pins at the same rate; do not pull one end of the connector off before the other


Write a review

Note: HTML is not translated!
    Bad           Good

Recently viewed

Powered By OpenCart
Evelta © 2019

Contact Us

How can we help ?