Pre calibrated with resistive sense technology coupled with NTC thermistor, for the precise reading of the relative Humidity and surrounding temperature DHT 11 break-out board is a very popular, low cost sensor from Aosong, the breakout provides easy installation of the DHT11 sensor module.
The board is also equipped with high- performance 8-Bit microcontroller which is connected to the DHT11 sensor module. Theoutput of the DHT11 is in the form of digital signal on a single data pin. The sensing update frequency is to be measured at every 2sec (0.5Hz).
The complete arrangement makes the device an ideal sensing setup to be hooked up directly to any kind of microcontroller boards like Arduino’s. The board is extra featured with on-board LED, a bypass capacitor between Vcc and Gnd and a pull-up resistor across data line and Vcc.